Hirdetés

Új hozzászólás Aktív témák

  • kovaax

    őstag

    Na, most olyan hibába futottam, ami eddig nem volt. Bedugom az usb botomat, felismeri, fel is tudom mountolni. De ha írni akarok rá, akkor pár perc próbálkozás után hibával leáll, és lemountolja. Két bigyóval is kipróbáltam, mindkettővel ugyanaz a probléma. Ugyanezen a gépen van Ubuntu is, az tudja írni rendesen, hiba nélkül (szóval nem hardveres a probléma). Kb. az utolsó kernel frissülés óta van ez Fedora alatt is. Ez van a messagesben:

    Feb 19 17:54:11 localhost kernel: [ 94.697028] usb 2-4: new high-speed USB device number 2 using ehci_hcd
    Feb 19 17:54:11 localhost kernel: [ 94.813447] usb 2-4: New USB device found, idVendor=0930, idProduct=6544
    Feb 19 17:54:11 localhost kernel: [ 94.813453] usb 2-4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
    Feb 19 17:54:11 localhost kernel: [ 94.813457] usb 2-4: Product: DataTraveler 2.0
    Feb 19 17:54:11 localhost kernel: [ 94.813461] usb 2-4: Manufacturer: Kingston
    Feb 19 17:54:11 localhost kernel: [ 94.813464] usb 2-4: SerialNumber: 001E4FAB7F6BC8C1A57802C6
    Feb 19 17:54:12 localhost kernel: [ 94.913232] Initializing USB Mass Storage driver...
    Feb 19 17:54:12 localhost kernel: [ 94.915027] scsi2 : usb-storage 2-4:1.0
    Feb 19 17:54:12 localhost kernel: [ 94.915644] usbcore: registered new interface driver usb-storage
    Feb 19 17:54:12 localhost kernel: [ 94.915651] USB Mass Storage support registered.
    Feb 19 17:54:13 localhost kernel: [ 95.916664] scsi 2:0:0:0: Direct-Access Kingston DataTraveler 2.0 1.00 PQ: 0 ANSI: 2
    Feb 19 17:54:13 localhost kernel: [ 95.918077] sd 2:0:0:0: Attached scsi generic sg3 type 0
    Feb 19 17:54:13 localhost kernel: [ 95.919447] sd 2:0:0:0: [sdc] 15646656 512-byte logical blocks: (8.01 GB/7.45 GiB)
    Feb 19 17:54:13 localhost kernel: [ 95.919947] sd 2:0:0:0: [sdc] Write Protect is off
    Feb 19 17:54:13 localhost kernel: [ 95.920359] sd 2:0:0:0: [sdc] No Caching mode page present
    Feb 19 17:54:13 localhost kernel: [ 95.920367] sd 2:0:0:0: [sdc] Assuming drive cache: write through
    Feb 19 17:54:13 localhost kernel: [ 95.923336] sd 2:0:0:0: [sdc] No Caching mode page present
    Feb 19 17:54:13 localhost kernel: [ 95.923346] sd 2:0:0:0: [sdc] Assuming drive cache: write through
    Feb 19 17:54:13 localhost kernel: [ 95.925018] sdc: unknown partition table
    Feb 19 17:54:13 localhost kernel: [ 95.926932] sd 2:0:0:0: [sdc] No Caching mode page present
    Feb 19 17:54:13 localhost kernel: [ 95.926941] sd 2:0:0:0: [sdc] Assuming drive cache: write through
    Feb 19 17:54:13 localhost kernel: [ 95.926947] sd 2:0:0:0: [sdc] Attached SCSI removable disk
    Feb 19 17:54:24 localhost kernel: [ 107.055333] EXT4-fs (sdc): mounted filesystem with ordered data mode. Opts: (null)
    Feb 19 17:54:24 localhost udisksd[1424]: Mounted /dev/sdc at /run/media/peter/af38a901-0bf2-4b54-b954-b57b28feec20 on behalf of uid 1000
    Feb 19 17:54:30 localhost dbus-daemon[511]: dbus[511]: [system] Activating service name='net.reactivated.Fprint' (using servicehelper)
    Feb 19 17:54:30 localhost dbus[511]: [system] Activating service name='net.reactivated.Fprint' (using servicehelper)
    Feb 19 17:54:30 localhost dbus-daemon[511]: dbus[511]: [system] Successfully activated service 'net.reactivated.Fprint'
    Feb 19 17:54:30 localhost dbus[511]: [system] Successfully activated service 'net.reactivated.Fprint'
    Feb 19 17:54:30 localhost dbus-daemon[511]: Launching FprintObject
    Feb 19 17:54:30 localhost dbus-daemon[511]: ** Message: D-Bus service launched with name: net.reactivated.Fprint
    Feb 19 17:54:30 localhost dbus-daemon[511]: ** Message: entering main loop
    Feb 19 17:55:00 localhost dbus-daemon[511]: ** Message: No devices in use, exit
    Feb 19 17:55:14 localhost kernel: [ 156.882031] usb 2-4: reset high-speed USB device number 2 using ehci_hcd
    Feb 19 17:55:29 localhost kernel: [ 172.018032] usb 2-4: device descriptor read/64, error -110
    Feb 19 17:55:44 localhost kernel: [ 187.255031] usb 2-4: device descriptor read/64, error -110
    Feb 19 17:55:44 localhost kernel: [ 187.458029] usb 2-4: reset high-speed USB device number 2 using ehci_hcd
    Feb 19 17:55:59 localhost kernel: [ 202.595030] usb 2-4: device descriptor read/64, error -110
    Feb 19 17:56:14 localhost kernel: [ 217.834031] usb 2-4: device descriptor read/64, error -110
    Feb 19 17:56:15 localhost kernel: [ 218.037030] usb 2-4: reset high-speed USB device number 2 using ehci_hcd
    Feb 19 17:56:25 localhost kernel: [ 228.461030] usb 2-4: device not accepting address 2, error -110
    Feb 19 17:56:25 localhost kernel: [ 228.563030] usb 2-4: reset high-speed USB device number 2 using ehci_hcd
    Feb 19 17:56:36 localhost kernel: [ 238.988031] usb 2-4: device not accepting address 2, error -110
    Feb 19 17:56:36 localhost kernel: [ 238.988075] usb 2-4: USB disconnect, device number 2
    Feb 19 17:56:36 localhost kernel: [ 238.988188] sd 2:0:0:0: Device offlined - not ready after error recovery
    Feb 19 17:56:36 localhost kernel: [ 238.991430] sd 2:0:0:0: [sdc] Unhandled error code
    Feb 19 17:56:36 localhost kernel: [ 238.991438] sd 2:0:0:0: [sdc]
    Feb 19 17:56:36 localhost kernel: [ 238.991442] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
    Feb 19 17:56:36 localhost kernel: [ 238.991445] sd 2:0:0:0: [sdc] CDB:
    Feb 19 17:56:36 localhost kernel: [ 238.991448] Write(10): 2a 00 00 00 0f f8 00 00 08 00
    Feb 19 17:56:36 localhost kernel: [ 238.991461] end_request: I/O error, dev sdc, sector 4088
    Feb 19 17:56:36 localhost kernel: [ 238.991467] Buffer I/O error on device sdc, logical block 511
    Feb 19 17:56:36 localhost kernel: [ 238.991469] lost page write due to I/O error on sdc
    Feb 19 17:56:36 localhost kernel: [ 238.991569] EXT4-fs error (device sdc): ext4_read_inode_bitmap:175: comm tar: Cannot read inode bitmap - block_group = 0, inode_bitmap = 495
    Feb 19 17:56:36 localhost kernel: [ 238.991663] EXT4-fs error (device sdc) in ext4_new_inode:942: IO failure
    Feb 19 17:56:36 localhost kernel: [ 238.991668] EXT4-fs (sdc): previous I/O error to superblock detected
    Feb 19 17:56:36 localhost kernel: [ 238.999109] Aborting journal on device sdc-8.
    Feb 19 17:56:36 localhost kernel: [ 238.999150] JBD2: Error -5 detected when updating journal superblock for sdc-8.
    Feb 19 17:56:36 localhost kernel: [ 238.999161] journal commit I/O error
    Feb 19 17:56:36 localhost systemd-udevd[1581]: inotify_add_watch(7, /dev/sdc, 10) failed: No such file or directory
    Feb 19 17:56:36 localhost udisksd[1424]: Cleaning up mount point /run/media/peter/af38a901-0bf2-4b54-b954-b57b28feec20 (device 8:32 no longer exist)
    Feb 19 17:56:36 localhost kernel: [ 239.101064] usb 2-4: new high-speed USB device number 3 using ehci_hcd
    Feb 19 17:56:36 localhost kernel: [ 239.213308] EXT4-fs error (device sdc): ext4_put_super:858: Couldn't clean up the journal
    Feb 19 17:56:36 localhost kernel: [ 239.213319] EXT4-fs (sdc): Remounting filesystem read-only
    Feb 19 17:56:51 localhost kernel: [ 254.239025] usb 2-4: device descriptor read/64, error -110
    Feb 19 17:57:06 localhost kernel: [ 269.423186] hub 2-0:1.0: unable to enumerate USB device on port 4

    Van valakink valami ötlete?

Új hozzászólás Aktív témák