Ez katasztrófa, ilyen alacsony írást nem is tudom hogy lehet elérni, single channelben is kevés.
Rakd a DIMM1 és DIMM2-vel jelzett slotokba a RAM-ot, adj neki 2.1V-ot, ...

DRAM Timing Selectable: Manual
DRAM Clock: DDRII 800
DQS Timing Training: Skip DQS
CKE Base Power Down Mode: Enabled
CKE Base Power Down By: Channel
Memclock Tri-Stating: Disabled
TwTr Command Delay: 3 Clocks
Trfc0 for DIMM1: 127.5 ns
Trfc1 for DIMM2: 127.5 ns
Trfc2 for DIMM3: 127.5 ns
Trfc3 for DIMM4: 127.5 ns
Write Recovery Time (Twr): 6 Clocks
Precharge Time (Trtp): 4 Clocks
Row Cycle Time (Trc): 20 Clocks
RAS to CAS Delay (Trcd): 4 Clocks
RAS to RAS Delay (Trrd): 3 Clocks
Row Precharge Time (Trp): 4 Clocks
Min. RAS Act-Time (Tras): 12 Clocks
CAS Latency: 4 Clocks
Command Rate: 2T
Memory Hole Remapping: Enabled
DRAM ECC: Disabled

Az FSB-t meg megemelheted 218-ra, akkor pont 800-on fog menni a RAM. (ehhez lehet hogy a CPU-nak is kell egy kis fesz, 0.025-0.05V)

"Only two things are infinite, the universe and human stupidity, and I'm not sure about the former." (Albert Einstein)