Szia!

Próbáld ezzel...

# This is an example resource file for rTorrent. Copy to
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.
# Minumum amount of peers to connect per torrent, if available.
min_peers = 1
# Minumum amount of peers to connect per torrent.
max_peers = 50
# Same as above but for seeding completed torrents (-1 = same as downloading)
# min_peers_seed = 2
# max_peers_seed = 50
# Maximum number of simultanious uploads per torrent.
max_uploads = 5
# Global download rate in KiB. .0. for unlimited.
download_rate = 1536
# Global upload rate in KiB. .0. for unlimited.
upload_rate = 384
# Default directory to save downloaded files. Note it doesn.t support
# space yet.
directory = /mmc/rtorrent/work/
# Watch a directory for new torrents, and stop those that have been deleted.
# schedule = watch_directory,5,5,load_start=/opt/share/torrent/dl/*.torrent
# schedule = untied_directory,5,5,stop_untied=
# Close torrents when diskspace is low.
# schedule = low_diskspace,5,60,close_low_diskspace=100M
# Default session directory. Make sure you don.t run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session = /mmc/rtorrent/session
# The ip address reported to the tracker.
# ip = rakshasa
# The ip address the listening socket and outgoing connections is
# bound to.
# Port range to use for listening.
port_range = 6890-6890
# Start opening ports at a random position within the port range.
# port_random = no
# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
check_hash = no
# Set whetever the client should try to connect to UDP trackers.
# use_udp_trackers = yes
# Alternative calls to bind and ip that should handle dynamic ip.s.
# schedule = ip_tick,0,1800,ip=rakshasa
# schedule = bind_tick,0,1800,bind=rakshasa
#
# Do not modify the following parameters unless you know what you.re doing.
#
# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
# hash_read_ahead = 10
# Interval between attempts to check the hash, in milliseconds.
# hash_interval = 100
# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
# hash_max_tries = 10
# Max number of files to keep open simultaniously.
max_open_files = 32
# Number of sockets to simultaneously keep open.
max_open_sockets = 32
# Example of scheduling commands: Switch between two ip.s every 5
# seconds.
# schedule = .ip_tick1,5,10,ip=torretta.
# schedule = .ip_tick2,10,10,ip=lampedusa.
# Remove a scheduled event.
# schedule_remove = .ip_tick1.
# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
# schedule = ratio,60,60,.stop_on_ratio=200,200M,2000.
# schedule = ratio,30,60,stop_on_ratio=200
# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
encryption = allow_incoming,enable_retry,prefer_plaintext
# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to .disable. (completely disable DHT), .off. (do not start DHT),
# .auto. (start and stop DHT as needed), or .on. (start DHT immediately).
# The default is .off.. For DHT to work, a session directory must be defined.
#
# dht = auto
# UDP port to use for DHT.
#
# dht_port = 6880
# Enable peer exchange (for torrents not marked private)
#
# peer_exchange = yes
max_memory_usage = 64M
scgi_port = 127.0.0.1:5000