Aktív témák

• #10 e-biza őstag

  2003-12-13 14:24:54 #10

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  e-biza

  őstag

  ------------------------------------------------------------------------------------------------------------
  XF86Config File modifications
  ------------------------------------------------------------------------------------------------------------
  
  You will now need to edit your /etc/X11/XF86Config file for the Xserver to use the new module.
  In the NVIDIA readme there are instructions on what to edit, but since most people don't read those things I'll go into it here. depending on your version, you may have either a XF86Config or XF86Config-4 file. Redhat and slackware use XF86Config.
  
  Make a backup just in case:
  cp /etc/X11/XF86Config /etc/X11/XF86Config-bak
  
  There are a few things you need to edit:
  Driver ''nv'' (or Driver ''vesa'')
  with
  Driver ''nvidia''
  
  In the Module section, make sure you have:
  Load ''glx''
  
  You should also remove the following lines or comment them out with a # so they look like this:
  #Load ''dri''
  #Load ''GLcore''
  
  Save the file, and exit the editor.
  
  
  Once you are done editing this file you need to change the 3 back to a 5 in your /etc/inittab file discussed earlier. And you can reboot your system now. If it boots up to a graphical login you will see the Nvidia splash screen come up before the login prompt comes up. If you boot into a text mode, you will see the Nvidia splash screen come up after you type startx.
  
  
  Remélem segitett.

Aktív témák