Új hozzászólás Aktív témák

• #15936 meszimark tag

  Új Válasz 2018-05-15 15:24:48 #15936

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  meszimark

  tag

  Sziasztok, nekem van egy routeremet, ami a következő hibát dobja induláskor. Megoldható valahogy, hogy még működjön?

  U-Boot 1.1.4 (Mar 20 2013 - 15:11:17)

U-boot DB120


DRAM: 128 MB
id read 0x100000ff
flash size 8MB, sector count = 128
Flash: 8 MB
Using default environment

PCIe Reset OK!!!!!!
In: serial
Out: serial
Err: serial
Net: ag934x_enet_initialize...
No valid address in Flash. Using fixed address
wasp reset mask:c03300
WASP ----> S17 PHY *
: cfg1 0x7 cfg2 0x7114
eth0: ba:be:fa:ce:08:41
athrs17_reg_init: complete
eth0 up
eth0
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OK

Starting kernel ...

[ 0.000000] Linux version 3.7.4 (gavarga@gavarga-Inspiron-N5110) (gcc version 4.6.4 20121210 (prerelease) (Linaro GCC 4.6-2012.12) ) #2 Tue Jan 29 10:01:41 CET 2013
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 0001974c (MIPS 74Kc)
[ 0.000000] SoC: Atheros AR9344 rev 2
[ 0.000000] Clocks: CPU:560.000MHz, DDR:450.000MHz, AHB:225.000MHz, Ref:40.000MHz
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 08000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x07ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x07ffffff]
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512
[ 0.000000] Kernel command line: board=TL-WDR4300 console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes)
[ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] __ex_table already sorted, skipping sort
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 126512k/131072k available (2172k kernel code, 4560k reserved, 411k data, 228k init, 0k highmem)
[ 0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:51
[ 0.000000] Calibrating delay loop... 278.93 BogoMIPS (lpj=1394688)
[ 0.070000] pid_max: default: 32768 minimum: 301
[ 0.070000] Mount-cache hash table entries: 512
[ 0.080000] NET: Registered protocol family 16
[ 0.080000] MIPS: machine is TP-LINK TL-WDR3600/4300/4310
[ 0.090000] registering PCI controller with io_map_base unset
[ 0.310000] bio: create slab <bio-0> at 0
[ 0.310000] PCI host bridge to bus 0000:00
[ 0.320000] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff]
[ 0.320000] pci_bus 0000:00: root bus resource [io 0x0000]
[ 0.330000] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
[ 0.330000] pci 0000:00:00.0: invalid calibration data
[ 0.340000] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1001ffff 64bit]
[ 0.340000] pci 0000:00:00.0: BAR 6: assigned [mem 0x10020000-0x1002ffff pref]
[ 0.350000] pci 0000:00:00.0: using irq 40 for pin 1
[ 0.350000] Switching to clocksource MIPS
[ 0.360000] NET: Registered protocol family 2
[ 0.360000] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
[ 0.360000] TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.370000] TCP: Hash tables configured (established 4096 bind 4096)
[ 0.370000] TCP: reno registered
[ 0.380000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.380000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.390000] NET: Registered protocol family 1
[ 0.400000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.410000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.420000] msgmni has been set to 247
[ 0.420000] io scheduler noop registered
[ 0.430000] io scheduler deadline registered (default)
[ 0.430000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.460000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
[ 0.470000] console [ttyS0] enabled, bootconsole disabled
[ 0.470000] console [ttyS0] enabled, bootconsole disabled
[ 0.480000] ath79-spi ath79-spi: master is unqueued, this is deprecated
[ 0.490000] m25p80 spi0.0: found s25fl064k, expected m25p80
[ 0.490000] m25p80 spi0.0: s25fl064k (8192 Kbytes)
[ 0.500000] 5 tp-link partitions found on MTD device spi0.0
[ 0.500000] Creating 5 MTD partitions on "spi0.0":
[ 0.510000] 0x000000000000-0x000000020000 : "u-boot"
[ 0.520000] 0x000000020000-0x000000103b0c : "kernel"
[ 0.520000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.530000] 0x000000103b0c-0x0000007f0000 : "rootfs"
[ 0.540000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.550000] mtd: partition "rootfs" set to be root filesystem
[ 0.560000] mtd: partition "rootfs_data" created automatically, ofs=760000, len=90000
[ 0.570000] 0x000000760000-0x0000007f0000 : "rootfs_data"
[ 0.570000] 0x0000007f0000-0x000000800000 : "art"
[ 0.580000] 0x000000020000-0x0000007f0000 : "firmware"
[ 0.720000] libphy: ag71xx_mdio: probed
[ 0.720000] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:RGMII
[ 1.300000] eth0: Atheros AR8327 switch driver attached.
[ 2.460000] ag71xx ag71xx.0 eth0: connected to PHY at ag71xx-mdio.0:00 [uid=004dd034, driver=Atheros AR8216/AR8236/AR8316]
[ 2.480000] TCP: cubic registered
[ 2.480000] NET: Registered protocol family 17
[ 2.480000] 8021q: 802.1Q VLAN Support v1.8
[ 2.490000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
[ 2.500000] Freeing unused kernel memory: 228k freed
[ 2.880000] SQUASHFS error: xz_dec_run error, data probably corrupt
[ 2.880000] SQUASHFS error: squashfs_read_data failed to read block 0x973e2
[ 2.890000] SQUASHFS error: Unable to read fragment cache entry [973e2]
[ 2.900000] SQUASHFS error: Unable to read page, block 973e2, size fa1c
[ 2.900000] SQUASHFS error: Unable to read fragment cache entry [973e2]
[ 2.910000] SQUASHFS error: Unable to read page, block 973e2, size fa1c
[ 2.920000] SQUASHFS error: Unable to read fragment cache entry [973e2]
[ 2.920000] SQUASHFS error: Unable to read page, block 973e2, size fa1c
[ 2.930000] SQUASHFS error: Unable to read fragment cache entry [973e2]
[ 2.940000] SQUASHFS error: Unable to read page, block 973e2, size fa1c
[ 2.940000] SQUASHFS error: Unable to read fragment cache entry [973e2]
[ 2.950000] SQUASHFS error: Unable to read page, block 973e2, size fa1c
[ 2.960000] Kernel panic - not syncing: No init found. Try passing init= option to kernel. See Linux Documentation/init.txt for guidance.

  Pastebin

Új hozzászólás Aktív témák