Hirdetés

Keresés

Új hozzászólás Aktív témák

  • Kernel

    nagyúr

    válasz Spet #58380 üzenetére

    Az a modul triggert igényel a bemenetére, amitől a relé meghúz és a beállított idő után elenged.

    De ha úgy gondoltad, hogy egy automatikus triggerrel állítanád be az eltolást, akkor is előbb ki kellene próbálni manuálisan, hogy egyáltalán működik-e az elgondolás.

    Egyébként áramszünet esetén ennek újra kellene indulnia? Mert van két üzemmódja, amikor egyáltalán nem indul automatikusan, csak triggerre:

    [Function 15] :
    Unlimited Cycle Timing Mode A: the relay does not operate after power on, give CH1 connector a high pulse signal, when arrived the timing time T1, the relay pull-in, when arrived the timing time T2, the relay disconnect, then repeat the above status, T1 and T2 can be adjustable between 0.1 second -270 hours, give CH1 interface a high pulse signal again, repeat the above function.

    [Function 16] :
    Unlimited Cycle Timing Mode B: the relay does not operate after power on, give CH1 interface a high pulse signal, the relay pull-in immediately, when arrived the timing time T1, the relay disconnect, when arrived the timing time T2, the relay pull-in, then repeat the above status, T1 and T2 can be adjustable between 0.1 second -270 hours, give CH1 interface a high pulse signal again, repeat the above function.

Új hozzászólás Aktív témák