Aktív témák

• #44634 psyho777 tag olloczky #44631

  2009-12-10 15:21:59 #44634

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  psyho777

  tag

  válasz olloczky #44631 üzenetére

  nem a program fogja flashelni a biost... hanem a bios amit kiteszel floppyra.. utána a régi biosodat átlővöd alapértelmezettre... és utánna frissited..

  itt van hogy kell frisiteni:
  Update:

  1. Reboot.
  2. Press (tap) <DEL> during POST (Power-On Self Test) to enter BIOS Setup.
  3. Load BIOS Defaults (press <F5>).
  4. Insert the USB Flash Disk containing the BIOS file P5BDxxxx.ROM. (Note that the USB Flash Disk has to be inserted before boot to enter BIOS, otherwise it won't be detected).
  5. Save and Exit <F10>. (BIOS will now restart).
  6. During BIOS restart, press <DEL> to enter BIOS Setup again.
  7. Under Tools menu, select ASUS EZ Flash 2. It may take 20 seconds for the drives to show up. Select a drive in the left pane <Tab>. Use <Up> and <Down> arrows and <Enter> to select a drive. If you don't see the BIOS file in the right pane, check the other drives. Note that the drive letters are not the same here as in Windows and that no HDD's (NTFS devices) are shown here.
  8. Select the BIOS file (e.g. P5BD1101.ROM) and press <Enter> to start flashing. Supervise the update, which includes the following stages: Erasing - Flashing (writing) - Verification. BIOS will automatically restart when the update is ready.
  9. Disconnect the USB Flash Disk before/during the restart.
  10. Perform a C.P.R. (CPU Parameter Recall) which resets the chipset. Power down, remove power cord from the PSU for 2 minutes and then power up.
  11. Enter BIOS and load BIOS Defaults <F5> again.
  12. Reenter your preferred BIOS settings - if you are using AHCI or RAID mode, don't forget to set 'Configure SATA as' to [AHCI / RAID]. Also remember the settings for the JMicron Controller, Audio and Memory Voltage. Check also that the Boot Device Priority is ok.
  13. Save and Exit <F10> (automatic restart).
  14. Press <DEL> to enter BIOS Setup and make a final check that all BIOS settings are ok. Save any changes.

  Nemtudok helyesen irni, kéretik mindenkitől ne szivasson ezzel!!! BRUTAL NUTRITION ...,,The easy day was yesterday˝... || pls válaszolni a pm-ekre ...||

Aktív témák