Blog

[ ÚJ BEJEGYZÉS ]   [ ÚJ CIKK ]

• X200 Ubuntu 10.04 install után

  Here is what I did to tune up my lovely Lenovo x200.

  UPDATE for Ubuntu 13.04. The fan seems pretty quiet anyway and I have already done some compiling.
  The modification of the linux command line is still needed.

  Install some thinkpad stuff
  sudo apt-get install tp-smapi-dkms thinkfan

  tp-smapi-dkms enables enhanced battery stats and charging control.
  thinkfan allows software fan control. Mine would spend hours pumping out cold air.

  To make sure relevant modules will be loaded add the following lines to /etc/modules

  tp_smapi
  thinkpad_acpi

  Hard drive shock protection
  I just installed hdapsd and it works.

  Get it to actually turn off when you shutdown
  Edit /etc/default/grub changing the line that reads
  GRUB_CMDLINE_LINUX_DEFAULT="quiet splash"
  to read
  GRUB_CMDLINE_LINUX_DEFAULT="quiet splash acpi_osi=Linux"
  That also fixes the mute button.

  Better battery charge control
  To make the battery last longer avoid recharging it if it is only a little bit discharged, etc. as described here. Another tip: Never let the battery fully discharge, that hurts lithium ion batteries each time.

  # echo 50 > /sys/devices/platform/smapi/BAT0/start_charge_thresh
  # echo 90 > /sys/devices/platform/smapi/BAT0/stop_charge_thresh

  Folytatás...

  csiktor 14 éve

• Windows 7 GODMode

  Új mappa: GodMode.{ED7BA470-8E54-465E-825C-99712043E01C}

  csiktor 14 éve

• Firefox tuning

  A trükk: about:config

  Szűrés:
  network.http

  A szükséges sorok:
  * * network.http.pipelining
  * * network.http.proxy.pipelining
  * * network.http.pipelining.maxrequests

  A network.http.pipelining illetve a network.http.proxy.pipelining értékét állítsuk ture-ra.
  Ezt követően a network.http.pipelining.maxrequests értékét állítsuk 8-ra. (szintén dupla klikk)

  Utolsó lépésként egy új értéket kell felvennünk az about:config-ba. Ehhez kattintsunk jobb gombbal az ablakban, válasszuk a New/Integer ; ( nálam jobb klikk, ÚJ–>Egész) menüpontot. Névnek adjuk az „nglayout.initialpaint.delay”-t, értéknek pedig állítsuk be a 0-t.

  csiktor 14 éve